Geometry FTW

I was concerned about blowing out the front of the body while drilling the hole from the control cavity to the neck pickup cavity. Needn’t have worried, because Pythagoras. Below is the destination end.

dscn2189

Here’s the source end, from the control cavity.

dscn2188

The bridge pickup was a lot easier. It’s only about an inch between the two cavities.

dscn2190

I probably could have used a shorter drill bit.

dscn2191

The hole for the output jack will need to be enlarged and centered, but I wasn’t about to chuck a 3/4″ Forstner bit in a handheld drill.

dscn2192

Advertisements

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s